FreescaleTWR-RF-SNAP无线网状网络解决方案
2012-04-12
作者:Freescale公司
RF" title="RF">RF" title="RF">RF-SNAP无线网状网络解决方案是采用Synapse公司基于Freescale的MC13224V收发器平台的SM700 RF引擎.这种无线网络模块采用带大容量片上存储器的ARM7 32位处理器,并集成了12位ADC,工作频率2400 - 2483.5MHz,输出功率高达100mW,16个RF通路,户外LOS距离达1.5英里,而TWR-RF-SNAP无线网状网络模块可单独使用,也可和Tower System一起使用.本文介绍了Synapse公司的SM700 RF引擎主要特性和指标,方框图以及RF无线网状网络模块TWR-RF-SNAP主要特性,方框图和电路图.
Synapse raises the bar on integrated performance with its SM700 RF Engine® based on the Freescale™ MC13224V transceiver platform. This wireless network module uses an ARM7 32-bit processor with large on-chip memory and integrated 12-bit ADCs.
And like all RF Engines from Synapse, the Model SM700 comes with SNAP® already loaded and ready to perform right out of the box. SNAP is Synapse’s award-winning, mesh network operating system that provides wireless connectivity for Internet-to-machine and machine-to-machine communications.
With 96K RAM of memory, large applications can bring intelligence to the very edge of the network for local operations. These applications can be uploaded over-the-air… even mesh hopping across the network to reach its destination. And because of the large memory in the SM700, the core SNAP operating system can also be upgraded over-the-air and leaves your network in place and intact.
Very little board space is needed for this RF Engine (25mm x 36mm). Even the antenna is integrated to further reduce system size and cost. What comes in a small package however is big on capabilities. The SM700 can achieve a range of over 1.5 miles and deliver an output of up to +20dBm. For applications requiring battery power, the Model SM700 can perform at power consumption levels as low as 12 μA.
SM700 RF引擎主要特性:
Powerful 32-bit TDMI ARM7 microprocessor
2.4 GHz RF Frequency (2400 - 2483.5MHz)
Up to 100mW output power
16 RF Channels
Small footprint: 1” x 1.4” (25.4mm x 36.5mm)
Integrated F-antenna
Over 1.5 miles range
AES 128-bit encryption
FCC, CE and IC certified Accurate 12-bit ADC for precision sensors
Large on-board memory resources
-96 dBm Rx sensitivity
+20dBm Tx output power
2.0 to 3.6 Volts Vcc
Low power consumption:
Transmit mode……193 mA
Receive mode………30 mA
Hibernate mode……1.1 µA
Operating temperature: -40℃ to +85℃
Small surface-mount IC footprint
SM700 RF引擎指标:
图1. SM700 RF引擎方框图
RF无线网状网络模块TWR-RF-SNAP
The Wireless Mesh Networking Tower Board (TWR-RF-SNAP) is a peripheral Tower System Module. The TWR-RF-SNAP provides wireless mesh networking via the FCC Certified Synapse Wireless SM700 RF Engine. The SM700 is based on the Freescale MC13224 chip which combines a 32-bit ARM7 MCU with an IEEE 802.15.4 radio transceiver.
The TWR-RF-SNAP module can function standalone or within the Tower System. As part of the Tower System, the TWR-RF-SNAP can interface with Tower System controller modules via SPI and can access available Tower System peripheral modules using UART or I2C. The TWR-RF-SNAP also includes a General Purpose Tower Plug-in (TWRPI) socket allowing direct access to a selection of sensor plug-ins via I2C.
A SN132 USB Dongle is also included with the TWR-RF-SNAP. The USB Dongle features the RF100 RF Engine based on a Freescale MC9S08 MCU and the Freescale MC13191 radio. The USB dongle provides a communication portal to a host computer via USB.
The TWR-RF-SNAP can be accessed in Synapse’s Portal IDE using either the on-board USB or wirelessly using the included RF100 USB Dongle.
RF无线网状网络模块TWR-RF-SNAP主要特性:
Features the SM700 802.15.4 RF Engine from Synapse Wireless, based on the Freescale MC13224 module
Pre-loaded with SNAP Network Operating System
Push button inputs and user controlled LEDs
On-board low-power linear active thermistor and light sensor
On-board TWRPI connector for the addition of standard Freescale TWRPI modules
Configurable access to Tower Elevator connector allows for interaction with other Tower modules (UART, SPI and I 2C)
MicroUSB connector provides power and serial connectivity
Multiple powering options
Access to additional GPIOs on SM700 via header bloc
图2.TWR-RF-SNAP方框图
图3.TWR-RF-SNAP模块外形图
图4.TWR-RF-SNAP模块电路图(1)
图5.TWR-RF-SNAP模块电路图(2)
图6.TWR-RF-SNAP模块电路图(3)
图7.TWR-RF-SNAP模块电路图(4)
详情请见:
http://cache.freescale.com/files/32bit/doc/user_guide/TWR_RF_SNAP_UM.pdf?fpsp=1&WT_TYPE=Users%20Guides&WT_VENDOR=FREESCALE&WT_FILE_FORMAT=pdf&WT_ASSET=Documentation
和
http://cache.freescale.com/files/32bit/hardware_tools/schematics/TWR_RF_SNAP_SCH.pdf?fpsp=1
以及
http://www.synapse-wireless.com/documents/products/Synapse-SM700xx-Engine-Data-Sheet.pdf
Synapse raises the bar on integrated performance with its SM700 RF Engine® based on the Freescale™ MC13224V transceiver platform. This wireless network module uses an ARM7 32-bit processor with large on-chip memory and integrated 12-bit ADCs.
And like all RF Engines from Synapse, the Model SM700 comes with SNAP® already loaded and ready to perform right out of the box. SNAP is Synapse’s award-winning, mesh network operating system that provides wireless connectivity for Internet-to-machine and machine-to-machine communications.
With 96K RAM of memory, large applications can bring intelligence to the very edge of the network for local operations. These applications can be uploaded over-the-air… even mesh hopping across the network to reach its destination. And because of the large memory in the SM700, the core SNAP operating system can also be upgraded over-the-air and leaves your network in place and intact.
Very little board space is needed for this RF Engine (25mm x 36mm). Even the antenna is integrated to further reduce system size and cost. What comes in a small package however is big on capabilities. The SM700 can achieve a range of over 1.5 miles and deliver an output of up to +20dBm. For applications requiring battery power, the Model SM700 can perform at power consumption levels as low as 12 μA.
SM700 RF引擎主要特性:
Powerful 32-bit TDMI ARM7 microprocessor
2.4 GHz RF Frequency (2400 - 2483.5MHz)
Up to 100mW output power
16 RF Channels
Small footprint: 1” x 1.4” (25.4mm x 36.5mm)
Integrated F-antenna
Over 1.5 miles range
AES 128-bit encryption
FCC, CE and IC certified Accurate 12-bit ADC for precision sensors
Large on-board memory resources
-96 dBm Rx sensitivity
+20dBm Tx output power
2.0 to 3.6 Volts Vcc
Low power consumption:
Transmit mode……193 mA
Receive mode………30 mA
Hibernate mode……1.1 µA
Operating temperature: -40℃ to +85℃
Small surface-mount IC footprint
SM700 RF引擎指标:
图1. SM700 RF引擎方框图
RF无线网状网络模块TWR-RF-SNAP
The Wireless Mesh Networking Tower Board (TWR-RF-SNAP) is a peripheral Tower System Module. The TWR-RF-SNAP provides wireless mesh networking via the FCC Certified Synapse Wireless SM700 RF Engine. The SM700 is based on the Freescale MC13224 chip which combines a 32-bit ARM7 MCU with an IEEE 802.15.4 radio transceiver.
The TWR-RF-SNAP module can function standalone or within the Tower System. As part of the Tower System, the TWR-RF-SNAP can interface with Tower System controller modules via SPI and can access available Tower System peripheral modules using UART or I2C. The TWR-RF-SNAP also includes a General Purpose Tower Plug-in (TWRPI) socket allowing direct access to a selection of sensor plug-ins via I2C.
A SN132 USB Dongle is also included with the TWR-RF-SNAP. The USB Dongle features the RF100 RF Engine based on a Freescale MC9S08 MCU and the Freescale MC13191 radio. The USB dongle provides a communication portal to a host computer via USB.
The TWR-RF-SNAP can be accessed in Synapse’s Portal IDE using either the on-board USB or wirelessly using the included RF100 USB Dongle.
RF无线网状网络模块TWR-RF-SNAP主要特性:
Features the SM700 802.15.4 RF Engine from Synapse Wireless, based on the Freescale MC13224 module
Pre-loaded with SNAP Network Operating System
Push button inputs and user controlled LEDs
On-board low-power linear active thermistor and light sensor
On-board TWRPI connector for the addition of standard Freescale TWRPI modules
Configurable access to Tower Elevator connector allows for interaction with other Tower modules (UART, SPI and I 2C)
MicroUSB connector provides power and serial connectivity
Multiple powering options
Access to additional GPIOs on SM700 via header bloc
图2.TWR-RF-SNAP方框图
图3.TWR-RF-SNAP模块外形图
图4.TWR-RF-SNAP模块电路图(1)
图5.TWR-RF-SNAP模块电路图(2)
图6.TWR-RF-SNAP模块电路图(3)
图7.TWR-RF-SNAP模块电路图(4)
详情请见:
http://cache.freescale.com/files/32bit/doc/user_guide/TWR_RF_SNAP_UM.pdf?fpsp=1&WT_TYPE=Users%20Guides&WT_VENDOR=FREESCALE&WT_FILE_FORMAT=pdf&WT_ASSET=Documentation
和
http://cache.freescale.com/files/32bit/hardware_tools/schematics/TWR_RF_SNAP_SCH.pdf?fpsp=1
以及
http://www.synapse-wireless.com/documents/products/Synapse-SM700xx-Engine-Data-Sheet.pdf
本站内容除特别声明的原创文章之外,转载内容只为传递更多信息,并不代表本网站赞同其观点。转载的所有的文章、图片、音/视频文件等资料的版权归版权所有权人所有。本站采用的非本站原创文章及图片等内容无法一一联系确认版权者。如涉及作品内容、版权和其它问题,请及时通过电子邮件或电话通知我们,以便迅速采取适当措施,避免给双方造成不必要的经济损失。联系电话:010-82306116;邮箱:aet@chinaaet.com。